To Configure Auto Tune

Before you can configure Auto Tune, you will need an Auto Tune kit.

Note: Map Switch and Auto Tune can not be enabled at the same time.

1	Select Power Commander Tools Configure Auto Tune.

2	Select the Auto Tune Enabled box to enable or disable Auto Tune.

3	Select the Enable Hardware Switch box. When selected, Auto Tune will not start until the switch on the handle bar is toggled.

4	Enable or disable the Require Run Time.

Minimum Run Time—is the length of time after startup before Auto Tune starts.

5	Enable or disable the Require Engine Temp.

Minimum Temp—Auto Tune will not start until this engine temperature is reached. Enter a temperature in Fahrenheit if Harley ECM Data is enabled and configured. For an analog temperature sensor, the units are dependent on the settings entered in the Engine Temperature tab.

6	Enter the Trim Settings.

The Max Enrichment Trim/Max Enleanment Trim—the maximum percentage of fuel changes Auto Tune will make during an Auto Tune session.

7	Using the drop-down list, select the number of O2 sensors.

8	Click OK to accept the changes.

Or

Click Cancel to exit the window with no changes.

9	Click Yes to disable the map switch feature and enable Auto Tune.

Note: Map Switch and Auto Tune can not be enabled at the same time.

10	Click Yes to add Auto Tune tables.

Note: The map position 2 tables will be replaced by Auto Tune tables. You cannot have map position 2 tables and Auto Tune tables at the same time.